How to estimate clothing materials?

When the pattern is finished, the amount of fabric used should be estimated. The amount of fabric can be obtained by pattern typesetting, while experienced professionals can estimate the amount of fabric according to the length of clothes, sleeves, skirts and trousers. Because the width of the fabric is different, the estimation should be based on the width of the fabric. In addition, the lattice fabrics need to add more than one length of the lattice on the basis of the general fabric estimation when estimating the lattice fabrics.
1. Estimation of women's wear materials
There are many kinds of women's clothes. Different types of clothes have different shapes, and their amount of fabrics and estimates are also different. Here are some methods of estimating fabric consumption for representative garments in the form of charts. (Fabric width, 110 cm or so is commonly known as & ldquo; single width & rdquo; fabric, mostly for some summer fashion or shirt fabric width. About 150 cm width is commonly known as & ldquo; double width & rdquo; (folded) fabric, mostly suit or coat fabric width.)
It can be seen here that when purchasing cloth, there are two situations: narrow width and long width. The width is determined by 110 meters. The width and width are determined by 150 meters.











2. Estimation of men's wear materials
Men's wear is relatively fewer, different types of clothing are relatively fixed, and the estimation of fabric consumption is relatively simple.



The weight of the seam above. The typesetting may not be too tight. Even 20cm.
Secondly, some situations will cause more wastage.
Some suede fabrics are arranged in reverse and forward directions, which may require the same vertical direction in typesetting, and may be damaged in typesetting.
Lattice strips are aligned at seams, especially horizontally. This will cause some loss in typesetting.
Positioning flowers. If you require a pattern to be in a fixed position, the loss is even greater.
These special cases need to be increased according to the calculation method given above.
The handicapped party is even worse. For example, if you make a wrong cut, you'll finish without adding seams. Ironing overheating, dyeing, picking, threading, loss of film and so on.